TOA Décor Clearcoat topcoat

TOA Décor Clearcoat is used as a topcoat on TOA Décor Stone. This product is able to build a thin, transparent film on the top for emphasizing the original granular appearance of TOA Décor Stone.

It was designed from Acrylic emulsion and good light fastness pigments, so could be used in areas where atmospheric pollution is a problem, thanks to some outstanding advantages:

- Good UV resistance

- Dirt pick-up resistance

- Good light fastness

- Sheen finishing with high beauty

- Easy to apply

View DetailCompact

Intended use:

TOA Décor Clearcoat is designed to use as the topcoat for TOA Décor Stone for protection and reducing dirt pick-up. TOA Décor Clearcoat also could be used for renovation to overcoat old stone effect textured coating surfaces after proper pre-treatment.

Technical Data

  • Components: Binder, powder, additives & water
  • Color: Transparent
  • Solids by volume (%): 25 ± 5
  • Theoretical coverage: 10 m²/liter/coat
  • Dry film thickness: 20-30 microns Volatile Organic Compound (VOCs) ≤ 50 g/L
  • The drying time, Relative Humidity (RH) 50%:
  • - Substrate temperature: 25°C - 30°C
  • - Surface (touch): dry 1h-2h
  • - Hard dry: 7 days
  • - Painting interval, minimum: 4h-6h. The actual drying time and painting interval time may be longer or shorter, depending on the ambient temperature, film thickness, ventilation, humidity, number of paint coatings, etc.

Construction methods

  • Application tools: Spray gun, brush, roller
  • Dilution: The paint is ready to use after proper stirring until homogeneous.

Construction Guide

SURFACE PREPARATION

New surface

Let the concrete, cement plaster and mortar must be cured at least 28 days in ambient condition (average temperature is 25°C -30°C, relative humidity <75%), the surface moisture is not exceed 16% (specialized measuring testing equipment). pH value is about 6-9.

Remove all dust, grease, wax, laitance, chalking and others contamination from the surface by specialized machine as: grinding, sanding, vacuum cleaner, high pressure water jet and proper cleanness.

Old surface

Remove all dust, fungus, algae, loose old paint or others contamination from the surface by specialized machine as: grinding, sanding, vacuum cleaner, high pressure water jet and proper cleanness.

Then, treat the areas attacked by fungus, algae with proper chemicals.

Wash the surface if required, let it fully dry, the substrate moisture must be lower than 16% (specialized measuring testing equipment).

Repair the damaged area. Cracks bigger than 0.1mm must be fixed and make smooth by plasters.

The surface must be hard, firm before application.

APPLICATION

For newly applied TOA Décor Stone surfaces, please note:

Allow the TOA Décor Stone layer to dry for at least 24–48 hours before applying the TOA Décor Clearcoat topcoat.

Apply 1–2 coats, with a 4–6 hour recoat interval.

Recommended paint system

Primer: 1 coat TOA Decor Penetrating primer 


Texture Coat: 1 - 2 coats TOA Décor Stone


Topcoat: 2 coats TOA Décor Clearcoat

Send us a message