TOA Roofseal Sun Block

• Application tools: Brush, roller, or high-pressure spray gun.
• After use: Clean the tools with clean water immediately after application.

Surface preparation:

• The surface must be clean from dust, cement laitance and oil grease.
• In case of mold and algae, brush and clean with TOA 113 Microkill leave it dry before coating with TOA Roofseal Sun Block.
• Deformed paint or coating must be thoroughly cleaned before application.
• Fill all cracks wide with TOA Polyurethane Sealant then leave it dry before coating with TOA Roofseal Sun Block.
• Repair concrete crumbling or big cracks on surfaces with TOA Latex Agent prior to coating.
• Polish the rust on metal surfaces prior to coating.

Application:

• Stir well at a slow speed before use, especially with pre-mixed colored waterproofing paint.
• For roofs, apply TOA Roofseal Sun Block, diluted with clean fresh water at a 3:1 ratio, as a primer coat, allowing to dry for 2-4 hours.
• For metal roofs, apply one coat of Rust Tech to prevent rust and improve adhesion.
• For old tile roofs, apply one coat of TOA Epoguard Varnish to improve adhesion.
• If necessary, reinforce with TOA Fiber Mesh to improve adhesion and prevent cracking, immediately after applying the primer coat, applying pressure to the reinforcing mesh on the surface.
• Apply TOA Roofseal Sun Block with a pressure spray gun in 2 or 3 coats, allowing each coat to dry for 2-4 hours.

Recommended:

• The cracks must be sealed before the primary coat. Reinforce with TOA Fiber mesh while wet before coating with TOA Roofseal Sun Block 2 – 3 coats.
• TOA Roofseal Sun Block should not be applied to new concrete less than 28 days old and other cementitious surfaces less than 7 days old.
• Do not use TOA Roofseal Sun Block while raining.
• TOA Roofseal Sun Block will have the highest effectiveness 7 days after installation
• TOA Roofseal Sun Block uses for waterproofing for all horizontal (roof deck) or vertical masonry surfaces not suitable for long term water ponding (water tank).
• TOA Roofseal Sun Block gets full resistance properties after 7 days.
• Wash all tools immediately after use with water.
• Contact TOA for further detailed method of statement for specific Preparation & application.