TOA 258 Plus Cement Membrane - Polymer-modified Cementitious Two Component Waterproofing

Name: TOA 258 Plus Cement Membrane - Polymer-modified Cementitious Two Component Waterproofing
Brand: TOA

Self-coloring paint

Color board

Technical Data

Product safety information

TOA 258 Plus Cement Membrane is a two pack cement waterproofing cement based. Part A is modified polymer liquid and part B is a pre-mixed powder compounds of cement, selected fine aggregate and special additives. These two components, when mixed together, form a liquid mortar solution that is convenient for application on mortar and concrete surfaces to form a high elastic coating with waterproof and protective properties.

TOA 258 Plus Cement Membrane has the following outstanding features and benefits:
- Prepackaged according to convenient mixing ratio for easy mixing and application.
- Improved polymer composition increases good adhesion on concrete and mortar.
- After mixing, it forms a layer of a flexible, high-viscosity solution that is convenient for application by brush or machine spray.
- Capable of covering cracks < 2 mm.
- Non-toxic product can be applied to residential water contact surfaces.

View DetailCompact

Intended use:

TOA 258 Plus Cement Membrane used professionally for waterproofing on concrete floors and wall surfaces, mortar, indoor and outdoor and used for new construction and renovation works such as:
- Waterproofing the inside of residential water tanks, fire water tanks, swimming pools, water holes, ...before plastering or finishing tiles.
- Waterproofing floors, walls of toilets, kitchens, laundry areas, balconies, loggias or wet areas,... before finishing tiles and stones.
- Waterproofing for retaining walls, balcony terraces,... with protective plaster.

Adhesion strength under normal conditions after 28 days: ≥ 0.5 MPa
Adhesion strength after heat ageing: ≥ 0.5 MPa
Crack bridging ability under standard condition: ≥ 0.75 mm
Water penetration under a water pressure of 1.5 bar for 7 days: Non-penetration
Elongation at break: ≥ 200%

Application tool: Electric mixer, trowel, brusher, roller or sprayer.
Mixing ratio: Mix ratio of components A - B = 1 - 1.5 by weight.
Equipment cleaning: Clean all tools and application equipment with clean water immediately after use. Hardened or cured material can be removed mechanically.

SURFACE PREPARATION

Concrete and mortar surfaces must be prepared clean, make sure there is no cement mortar, dust dirt, oil, grease, old coatings, curing agents or other impurities. Absorbent surfaces must be completely saturated before application. Repair defects in concrete such as voids, honeycomb holes, etc. with TOA repair mortar to create a flat and even surface. Moister and saturate the substrate surface before application TOA 258 Plus Cement Membrane.

MIXING

Mix with a mixer at low speed 300-500 rpm
Put ¾ part A in a clean pail. Keep stirring machine run slowly speed at 300-500 rpm, add part B slowly and mix at least 5 minutes to get a lump-free homogenous mix. Add part A remainder and mix until homogenous.

APPLICATION

- Apply the mixed screed by brush, roller or sprayer onto the treated surface clean as well as saturate the water completely.
- The application area is shielded from direct sunlight or wind to avoid rapid drying of the waterproofing membrane.
- Allow to dry at least 8 hours before applying the next coat.
- The actual drying time and coating interval time may be longer or shorter, depending on the ambient temperature, film thickness, ventilation, humidity, number of coatings, etc.
- Allow to dry at least 5 days before apply protection layer, completely dry for at least 7 days before putting into use.

CURING

- After application, it should be cured for at least 3-5 days, away from sunlight direct, high temperature or high wind, frost to avoid drying too quickly affecting the quality of the waterproofing membrane.
- Curing with plastic sheeting, damp sacks or professional concrete curing agents approved by TOA is recommended.

Please Contact TOA for further detailed method of statement for specific preparation & application: 1900 558822.

TOA 258 Plus Cement Membrane - Polymer-modified Cementitious Two Component Waterproofing

Intended use:

Technical Data

Construction methods

Construction Guide

Recommended paint system

Other products